Gree GWHD(48S)NM3CO Service Manual page 58

Super Free Match
Service Manual
Under cool mode, press SAVE button and the unit will operate under SAVE mode. Dual-8nixie tube on
remote controller displays "SE". Air conditioner will operate at auto speed. Set temperature can't be adjusted.
Press SAVE button again to exit SAVE mode. Air conditioner turn back to original set speed and set temperature.
This function is applicable to partial of models.
8) X-FAN:
After pressing this button under cooling or dry mode, remote controller displays the character of "X-FAN"
and X-FAN function is started up. Press this button again to cancel X-FAN function. The character of "X-FAN"
will disappear.
Note:
After starting up X-FAN function, when turning off the unit, indoor fan will continue to operate for a
while at low speed to dry the residual water inside the indoor unit.
When the unit operates under X-FAN mode, press "X-FAN" button can turn off X-FAN function.
Indoor fan stops operation immediately.
9) TEMP
Press this button can see indoor set temperature, indoor ambient temperature or outdoor ambient temperature
on indoor unit's display. Temperature is set circularly by remote controller as below:
When selecting "
set temperature.
When selecting "
ambient temperature.
When selecting "
ambient temperature.
Note:
Outdoor ambient temperature display may can't be selected for some models. When indoor unit receives
" " signal, it displays indoor set temperature.
Only for the model whose indoor unit has dual-8 display.
10) TIMER
At ON status, press this button once can set TIMER OFF. The character of HOUR and OFF will flash.
Press "＋" or "－" button within 5s can adjust the time of TIMER ON. After each pressing of "＋" or "
－" button, time will increase or decrease half an hour. When holding "＋" or "－" button, 2s later,
the time will change quickly until to reach to your required time. After that, press "TIMER" button to
confirm it. The character of HOUR and OFF won't flash again. Cancel TIMER OFF: Press "TIMER"
button again under TIMER OFF status.
At OFF status, press this button once can set TIMER ON. Please refer to TIMER off for detailed
operation.
Cancel TIMER ON: Press "TIMER" button again under TIMER ON status.
Note:
Time setting range: 0.5-24 hours.
CONTROL 54
" by remote controller or no display, temperature indicator on indoor unit displays
" by remote controller, temperature indicator on indoor unit displays indoor
" by remote controller, temperature indicator on indoor unit displays outdoor