Additional Features - Gamma 5003 Owner's Manual

STRINGING THE FRAME

ADDITIONAL FEATURES

Pulling Tension
Wrap the loose section of string once around
the roller guide and insert the string between
the diamond dust coated string gripper plates.
Pull the string perpendicular to the gripper
plates while slowly rotating the tensioner
crank clockwise until the brake lever pops
out of the latching block. The string is now
tensioned and can be clamped in place with
the remaining fixed clamp.
Repeat the above steps until all main strings
are installed. Tie off ends of main strings as
per racquet manufacturers recommenda-
tions.
Weaving the Cross Strings
Weave the cross strings over and under the
main strings being careful to alternate the
weave direction of each consecutive cross
string so as to be opposite of the previously
installed cross string.
Once the final cross string is tensioned and
clamped, tie off at the appropriate hole speci-
fied by the racquet manufacturer. Remove the
frame from the mounting system by loosening
the shoulder supports and frame supports.
Locking the Turntable
The turntable may be locked in any position.
The turntable winged lock knob is packed
separately. Install the lock knob into the
threaded hole located on the side of the
tensioner bar post.
Rotate the knob clockwise to lock the turn-
table, and counter-clockwise to release the
turntable.
12