Drone/Transmitter Binding; Drone Calibration - Kaiser Baas THETA User Manual

DRONE/TRANSMITTER BINDING

To operate your Drone, you must bind the Drone to your Transmitter before every flight.
Ensure your Drone and Transmitter are fully charged and follow these steps in order:
1. Turn on your Drone by pressing the ON/OFF switch.
2. The Drone lights will flash indicating it is ready to bind to a Transmitter.
3. Turn on the Transmitter.
4. Using the Left Throttle/Yaw Stick move it to the maximum UP position and return it
back to the zero position.
Note: you must complete this process within 5 seconds of powering on the
Transmitter or you will have to restart the process.
5. The Drone LED lights will stop flashing indicating the Drone is now paired to the
Transmitter.
Note: If you have more than one Drone you must pair them sequentially
(Bind one Drone and then bind the second Drone). Attempting to pair them
simultaneously may cause interference.

DRONE CALIBRATION

Before every flight it is important to calibrate your Drone.
Calibration ensures the Gyroscopes are reset and the Drones Direction / Heading is fixed.
Always calibrate with the Drone and the Pilot facing the same direction.
Calibration:
1. Place the Drone on level ground facing the same direction as the pilot.
2. Push the Left Throttle/Yaw Stick and the Right Pitch/Roll Stick to the bottom left and
hold for 2 seconds until you see the LED indicator lights on the drone start to flash
rapidly.
3. Release the sticks and wait for the drone LEDs to stop flashing.
4. The Drone LEDs will stop flashing indicating that the calibration has been completed.
THETA DRONE | User Guide
15