Battery Charging - Kaiser Baas THETA User Manual

BATTERY CHARGING

TO CHARGE THE DRONE BATTERY:
1. Remove the battery from the Drone by pressing the clip and sliding it out of the
Drone battery compartment.
2. Connect the USB Charger to the Battery terminal located on the battery. Note the
USB Charger has grooves that match the Battery terminal.
3. Connect the USB Charger to an electronic device.
Note: If using a wall charger, ensure that it is a certified product for your region.
AC Input: 100-240VAC 50/60Hz. DC Output: 5VDC 0.5A/1A/2.1A. Only use a USB
charger with suitable approval and certification. Do not charge in conditions outside
of the 10°C-45°C range.
4. The USB Charger features a red LED indicator light that will turn on when Charging is
complete or there is no battery connected. While it is charging the light will be OFF.
5. A full charge cycle will take approximately 70mins by 0.5A/1A/2.1A charger.
TO CHARGE THE DRONE BATTERY INSIDE THE THETA DRONE:
1. Make sure the Drone is switched OFF.
2. Insert the USB Charger into the charging (CHA) port
at the bottom of the Drone. Note the USB Charger
has grooves that match the charging (CHA) port.
[Diagram]
3. Connect the USB Charger to an electronic device.
4. Note: If using a wall charger, ensure that it is a certified
product for your region. AC Input: 100-240VAC
50/60Hz. DC Output: 5VDC 0.5A/1A/2.1A. Only use a
USB charger with suitable approval and certification.
Do not charge in conditions outside of the 10°C-45°C
range.
5. The USB Charger features a red LED indicator light
that will turn on when Charging is complete or there
is no battery connected. While it is charging the light
will be OFF.
6. A full charge cycle will take approximately 70mins by 0.5A/1A/2.1A charger.
REMOTE TRANSMITTER:
1. Unscrew the back plate of the Remote Transmitter
2. Insert 4 x AAA Batteries with the correct polarity.
3. Replace battery cover and reinstall the screw.
Note: Never mix different types of batteries
LOW BATTERY
The Drone LED Lights will flash when the drone is in Low Power Mode. When the LEDs
are flashing you should bring the Drone to a complete stop. Failure to note the Low
Battery signal may cause a sudden loss of power endangering Persons, Property and
the Drone.
Running the Battery completely flat will impact the health and future flight time of your
Drone.
THETA DRONE | User Guide
13