Before Startup - Kärcher BR 55/60 W Ep Instructions Manual

13 Pedal for raising/ lowering the cleaning
head
14 Wing nuts for tilting the vacuum bar
15 Level for adjusting the brush contact
pressure
16 Nameplate
17 Vacuum bar suspension
18 Fresh water level display
19 Water quantity regulator
20 Brush rollers (BR model) Disk brushes
(BD model) *
21 Cleaning head
22 Vacuum bar lowering lever
23 Cover for waste water/fresh water tank
24 Fluff filter
25 Filling nozzle for fresh water tank
26 Fresh water tank
27 Dirt water reservoir
28 Lid of air channel (installed firmly; can
only be removed by an expert)
29 Dosing equipment for dirt water
30 Fresh water tank lock
* not pictured
Program selection switch
3
2
1
1 OFF
Appliance is out of operation.
2 Scrubbing suction
Wet clean the floor and vacuum up dirt
water.
3 Wet scrubbing
Wet clean the floor and allow the deter-
gent to react.
4 Vacuuming
Suck in the dirt fleet.
5 Polishing
20
English
4
5
Polishing the floor without the applica-
tion of liquid.

Before Startup

Installing the Brushes
BD model
The sweep brushes must be installed be-
fore the initial operation (see "Maintenance
work").
BR model
The brushes are mounted.
Installing the Vacuum Bar
Insert the vacuum bar into the vacuum
bar suspension in such a manner that
the profiled sheet is positioned above
the suspension.
Tighten the cross-handles.
Insert the suction hose.
Unloading
Place long lateral boards of the packag-
ing as a ramp next to the pallet.
Fix the ramp on the pallet with nails.