Introduction and Installation
Installing the monitor station
Note:
L When connecting to a PBX, make sure the {PBX MODE} switch is set to {ON} before
installing the monitor station (page 28).
1
Install the mounting bracket to a wall using the wood screws (4 mm x 16 mm).
L Remove the mounting bracket from the rear of the monitor station beforehand.
L Before drilling, see page 13 for installation location.
Wood screws
2
Attach the power cable to the terminal. See page 26 for details on how to attach the power
cable.
L If you want to use your own power cable, see page 15 for the type and distance.
20
Mounting bracket
Wire (Not included)
83.5 mm
Wall
Terminal (Non polar)
Power cable