Handset Registration - VTech VSP600A Quick Start Manual

Handset Registration

Registering the handset to the base station
The handset is pre-registered to the base station. If the handset becomes
deregistered, perform the registration procedure as follows.
To register the handset:
1. Make sure the handset has a charged battery before proceeding.
Make sure the base station is connected to power.
2. Press MENU on the handset. The Main Menu appears.
3. Press to scroll to User settings and press SELECT.
q
4. Press to scroll to Registration and press SELECT
q
5. With Handset highlighted, press SELECT. The handset screen
displays instructions. Press
instructions.
6. On the base station, press the HANDSET LOCATOR button for at
least four seconds, and then release the button. Both LEDs on the
base station begin to flash.
7. Press the # key on the handset. The screen shows Please wait...
The process takes up to 10 seconds to complete. When the first
handset registers, it beeps and the screen displays HANDSET 1.
If the handset fails to register, place it in the charger again for a few
seconds, remove it, and repeat the registration procedure.
to continue reading the
NEXT
HANDSET 1
11:26PM 01/01
LINE MENU
17
.
Main Menu
Speed dial
Features
Status
User settings
BACK ENTER
User settings
Low batt tone
Link lost tone
Key Tone
Registration
BACK ENTER
Press and
hold HANDSET
LOCATOR key
at base for
4 seconds
NEXT