Preparing The Remote Control; Performing Quick Setup - Panasonic SC-HT545 Operating Instructions Manual

6

Preparing the remote control

STEP
Remote control
2
Insert so the poles (i and j) match those in the remote control.
3
R6/LR6, AA
7

Performing QUICK SETUP

STEP
The QUICK SETUP screen assists you to make necessary settings.
To display the picture from the main unit, turn on your television and change its video input mode (e.g. VIDEO 1, AV 1, etc.).
≥ To change your television's video input mode, refer to its operating instructions.
≥ This remote control can perform some basic television operations (➜ page 31).
ENTER
SETUP
10
Batteries
1
≥ Do not use rechargeable type
batteries.
DVD
RETURN
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ page 11), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
1
2
3
4
Select
Register
5
ENTER
6
To change these settings later
Select "QUICK SETUP" in the "Others" tab (➜ page 24).
Turn on the unit.
Select "DVD/CD".
Press and hold to show
the QUICK SETUP
screen.
Follow the messages
and make the settings.
Press to finish QUICK
SETUP.
Press repeatedly to exit.