Table of Contents
Advertisement
Chapter 4. Web Interface Configuration
Port-based Service Zones Configuration Example
After running through Setup Wizard on a factory default system, the DSA-3600 is ready to use the default
tag-based VLAN for separating networks.
Log in to the web management interface and enter "admin" for both the default username and password in
the Username and Password fields of the Administrator Login Page. After logging-in the web management
interface, from the Menu Tree, click System then Service Zones to enter the Service Zone Settings page.
Click Configure of the desired service zone to enter its Basic Settings page, and then enable the service zone
used for port-based service zone deployment.
Click System from the Menu Tree and then click LAN Port Mapping. Select Port-Based mode for service
zone.
Assume LAN1, LAN2, LAN3 will be used by Default service zone for internal staff while LAN4 is to be assigned
to another service zone for external guests only. In the abovementioned page, click LAN4's drop-down menu
to select the desired second zone such as 'SZ1' for LAN4 (select only enabled service zones). Click Apply and
reboot the system.
24
Advertisement
Table of Contents
