HP t630 Thin Client Troubleshooting Manual page 26

7. Remove the thin client access panel. See
WARNING!
cool before you touch them.
8. Locate the memory module on the system board. See
9. To remove a memory module , press outward on the two latches on each side of the memory module (1),
rotate the memory module up, and then pull the memory module out of the socket (2).
10. Slide the new memory module (1) into the socket at approximately a 30° angle, and then press the
memory module down (2) so that the latches lock it in place.
NOTE:
on the memory socket.
11. Replace the access panel. See
12. Replace the thin client stand.
13. Reconnect external devices, reconnect the power cord, and then turn the thin client on.
14. Lock any security devices that were disengaged when the thin client access panel was removed.
The thin client automatically recognizes the new memory when you turn on the thin client.
20 Chapter 3 Hardware changes
To reduce risk of personal injury from hot surfaces, allow the internal system components to
A memory module can be installed in only one way. Match the notch on the module with the tab
Removing and replacing the access panel on page
Removing and replacing the access panel on page
Locating internal components on page
10.
13.
10.