Installing An Internal Usb Flash Drive - HP t630 Thin Client Troubleshooting Manual

Installing an internal USB flash drive

There is one USB 3.0 flash drive port on the system board.
To install a USB flash drive:
1. Remove/disengage any security devices that prohibit opening the thin client.
2. Remove all removable media, such as USB flash drives, from the thin client.
3. Turn off the thin client properly through the operating system, and then turn off any external devices.
4. Disconnect the AC power cord from the AC outlet, and disconnect any external devices.
5. Remove the stand from the thin client.
6. Lay the unit flat on a stable surface with the right side up.
7. Remove the thin client access panel. See
WARNING!
cool before you touch them.
8. Locate the USB flash drive port on the system board.
9. Align the USB flash drive with the USB port and press the drive firmly into the port until it is securely seated.
10. Replace and latch the access panel, and then reinstall the rear I/O panel. See
access panel on page
11. Replace the thin client stand.
12. Reconnect the AC power cord and turn on the thin client.
13. Lock any security devices that were disengaged when the thin client access panel was removed.
18 Chapter 3 Hardware changes
To reduce risk of personal injury from hot surfaces, allow the internal system components to
10.
Removing and replacing the access panel on page 10.
Removing and replacing the