Weslo pursuit 360R WLEX1476.0 User Manual page 9

9. The Console (16) requires four AA batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the exercise cycle has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries into the Console. If you do not do
this, the console displays or other electronic
components may become damaged. Remove
the battery cover and insert four batteries into
the Console as shown. Make sure that the bat-
teries are oriented as shown by the diagram
inside the Console. Then, reattach the battery
cover.
10. While another person holds the Console (16)
near the Upright (13), connect the console wire
to the Extension Wire (52).
Then, insert the wires downward into the
Upright (13).
Tip: Avoid pinching the wires. Attach the
Console (16) to the Upright (13) with four M6 x
15mm Button Screws (46).
11. Identify the Left Pedal (24), which is marked
with an "L" sticker.
Using an adjustable wrench, firmly tighten the
Left Pedal (24) counterclockwise into the left
arm of the Crank (21).
Tighten the Right Pedal (not shown) clockwise
into the right arm of the Crank (21).
IMPORTANT: Tighten both pedals as firmly
as possible. After using the exercise cycle
for one week, retighten the pedals. For best
performance, keep the pedals tightened.
Adjust the left Pedal Strap (53) to the desired
position, and press the end of the Pedal Strap
onto the tab on the Left Pedal (24). Adjust the
right Pedal Strap (not shown) in the same
way.
12. Make sure that all parts are properly tightened before you use the exercise cycle. After assembly is com-
pleted, some extra parts may be left over. Place a mat under the exercise cycle to protect the floor.
9
Batteries
16
10
16
Avoid pinching
the wires
46
46
11
53
24
Tab
9
Battery
Cover
Console
Wire
52
13
21