HP 5400R zl2 Series Nstallation And Getting Started Manual page 61

Figure 2-6. Console Connection
1 Console Port
2 RJ-45 to DB9 console cable
supplied with the switch
3 Optional USB console cable (not
supplied)
4 To PC running a terminal emulator
program, or a VT-100 terminal
3. Power on the management console (terminal or PC). If you are using a
PC, start the PC terminal program.
4. For a direct console connection through the Console port:
a. Press Enter two or three times to display the copyright page, and the
message "Press any key to continue".
b. Press any key to display the switch console command (CLI) prompt;
for example: HP 5900#
c. Continue the console session to configure the switch by following the
procedure in "Minimal Configuration Through the Out-of-Band
Console Connection" on page 3-2
Installing the HP 5400R zl2 Switches
Installation Procedures
2-25