HP 5400R zl2 Series Nstallation And Getting Started Manual page 41

7.
8.
N o t e
9.
At this point, the switch is fully installed. See the rest of this chapter if you
need more detailed information on any of these installation steps.
Connect the switch to a power source
is mounted, plug it in to the nearby main power source.
Connect the network devices
network cables, connect other switches, hubs, routers, computers,
servers, printers, and other network devices to the switch ports. For more
information, see "Connect the Network Devices" on
The 10/100/1000-T ports on the v2 zl or v3 zl2 Modules comply with IEEE
802.3x standard which includes the Auto MDI/MDI-X feature. This
feature allows you to use straight-through twisted-pair cable for all of
your twisted-pair network connections.
Connect a console to the switch
to modify the switch's configuration, for example, to configure an IP
address so it can be managed using a web browser or from an SNMP
network management station. Configuration changes can be made easily
through the switch's console interface.
Installing the HP 5400R zl2 Switches
Installation Procedures
(page 2-21). Once the switch
(page 2-22). Using the appropriate
page
(optional—page 2-23). You may wish
2-22.
2-5