HP 5400R zl2 Series Nstallation And Getting Started Manual page 49

C a u t i o n
The switch power supplies are hot swappable; they can be installed while the
switch is receiving power from the supply in the other slot. But, as indicated
by the caution statement on the power supply, the supply must not be
connected to AC power before being installed or removed.
For safety and proper switch cooling, if either of the power supply slots are
not being used, make sure to attach the cover plate over the slot. Please see
the "Installation Precautions" on
For installation details, see the instructions in the manual that comes with the
power supply.
Insert the power supply into
the opening, then slide it all
the way in until it connects
to the switch. The power
supply face plate will be
flush with the back face of
the switch.
CAUTION:
.
Refer to the installation guide for proper power cord selection
.
Disconnect AC power from the power supply BEFORE installing or
removing the supply. Otherwise, damage to the equipment may result.
page 2-7
Installing the HP 5400R zl2 Switches
Installation Procedures
.
for more information.
2-13