Denon AVR-3803 Operating Instruction page 20

ENGLISH
Preset memory
The included remote control unit can be used to operate devices of different brands by registering the preset
number corresponding to the brand of your device.
For some models the remote control unit or the device may not operate properly. In this case, use the learning
function (page 21) to store your device's remote control signals in the included remote control unit.
For instructions on resetting the preset memory, see page 23.
1
Press the power ON/SOURCE button and the
OFF button at the same time.
• "PRE" appears on the remote control unit's
display.
2
Use the • and ª cursor buttons to display
"PRE" on the remote control unit, then press
the ENTER button.
The remote control unit's display switches
as follows each time the • and ª cursor
buttons are pressed.
PRE
LRN
CALL
PUNCH
BKLT
RST
3
The "SEL" indicator flashes and the device
selection mode is set.
Use the • and ª cursor buttons to display the
mode you want to preset, then press the
ENTER button.
The display switches as shown below each
time the • and ª cursor buttons are
pressed.
CD CDR MD TAPE
TV CABLE DBS VCR2 VCR1
It is also possible to select the mode
directly using the mode buttons.
20
1 DVD
4
2, 3
4
Referring to the included List
1 2 3
of Preset Codes, use the
4 5 6 number buttons to input the
preset
7 8 9
number) for the manufacturer
0
of the component whose
signals you want to store in
the memory.
5
"OK" is displayed when the signals are
registered and the mode is terminated.
6
To store the codes of another component in the
memory, repeat steps 1 to 5.
DVD
VDP
NOTES:
• Depending on the model and year of manufacture, this function cannot be used for some models, even if
they are of makes listed on the included list of preset codes.
• Some manufacturers use more than one type of remote control code. Refer to the included list of preset
codes to change the number and check.
• For the CDR/MD, DBS/CABLE, VCR-1/VCR-2 and DVD/VDP modes, the unused mode can be deleted.
To delete an unused mode, select the mode to be deleted when registering the preset memory, input
preset number "9999", then press the ENTER button.
For example, when the MD mode is deleted, only the CDR mode is displayed when the CDR/MD button is
pressed.
This setting can be canceled by resetting the preset memory or registering another preset signal.
1
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR1....................................................................HITACHI
CD, MD, TAPE, CDR, VDP, DVD ...............................DENON
VCR2, DBS ................................................................SONY
CABLE .......................................................................ABC
Operating a component stored in the preset memory
1
Press the mode selector button for the
component you want to operate.
2, 3
NOTE:
• For the DVD player remote control buttons,
function names may differ according to
manufactuer. Compare with the remote control
operation of the various components.
code (a 4-digit
AMP
1