Denon AVR-3803 Operating Instruction page 18

ENGLISH
Auto tuner preset
Use this to automatically search for FM broadcasts and store up to 40 stations at preset channels A1 to 8, B1 to
8, C1 to 8, D1 to 8 and E1 to 8.
NOTE:
• If an FM station cannot be preset automatically due to poor reception, use the "Manual tuning" operation to
tune in the station, then preset it using the manual "Preset memory" operation.
1
At the System Setup Menu select "Auto Tuner Presets".
2
Press the ENTER button.
The "Auto Preset Memory" screen appears.
3
Use the CURSOR button to select "Yes".
"Search" flashes on the screen and searching begins.
"Completed" appears once searching is completed.
The display automatically switches to screen.
Protecting the setting
• The system setup settings can be locked so that they cannot be changed easily.
1
At the System Setup Menu select "Setup Lock".
2
Switch to the Setup Lock screen.
3
Select "ON", to lock the system setup settings.
18
4
Press the ENTER button to finalize the setting and exit the system setup mode.
When the setup lock function is activated, the settings listed below cannot be changed,
and "Setup Locked" is displayed when related buttons are operated.
• System setup settings
• Surround parameter settings
• Tone control settings
• Channel level settings (including test tones)
To unlock, press the System Setup button again and display the Setup Lock screen, then
select "OFF" and press "ENTER".
System setup is complete. Once these settings are made, there is no need to change them unless
different AV components are connected or the speakers are repositioned.
After completing system setup
This button can be pressed at any time during the system setup process to complete the process.
1
At the System Setup Menu, press the SYSTEM SETUP button.
The changed settings are entered and the on-screen display turns off.
• On-screen display signals
Signals input to the AVR-3803
VIDEO signal Video signal output to
S-video signal
input jack VIDEO MONITOR OUT
input jack
(yellow) jack (yellow)
1
E E C
2
C E C
3
E C C
4
C C E
( C : E : ) ( C :
Signal No signal On-screen signals output
NOTE:
• When a component video signal is input and when the "Video Input Mode" is set to the component fixed
mode at system setup, the on-screen display is only displayed when the System Setup, Surround
Parameters and On Screen buttons are operated.
On-screen display signal output
Signal output to S- Video signal output to Color
video MONITOR OUT Difference (Component) Video
video jack MONITOR OUT jacks
C C
C C
C C
C C
E : )
On-screen signals not output