Mounting/Removal - Mitsubishi Electric MELSEC Q Series User Manual

5
SETTINGS AND PROCEDURES BEFORE
OPERATION
Number
Module power supply part
2)
terminal block
Extension communication part
3)
terminal block
Safety power supply, safety
4)
input part terminal block
Safety output part terminal
5)
block
6) Start-up mode setting switch
7) Safety part extension connector OUT
8) Module fixing hook
9) Module mounting lever
5.1.4
For mounting/removing the Q series safety relay module on/from the base unit, refer to the
QCPU User's Manual (Hardware Design, Maintenance and Inspection).
5
- 5 5.1 Q Series Safety Relay Module

5.1.4 Mounting/removal

Table 5.1 Part names (2/2)
Name
POWER
LOCAL COM
S INPUT
S OUTPUT
Mounting/removal
+ 24V: Module power supply + 24V terminal
24G: Module power supply 24G terminal
FG: Module power supply FG terminal
EA, EB, EG: Data terminal for extension communication
SLD: Shielding wire terminal
EP: Power supply terminal for extension module
+ 24V: Safety part power supply + 24V terminal
24G: Safety part power supply 24G terminal
XS0, XS1: Start-up/off check terminal
X0: Safety input X0 input terminal
COM: Safety input X0 COM terminal
X1: Safety input X1 input terminal
COM: Safety input X1 COM terminal
Z00, Z01: Safety relay output terminal
Z10, Z11: Safety relay output terminal
Z20, Z21: Safety relay output terminal
A switch for setting start-up mode
"A" side: Auto mode
"M" side: Manual mode
A connector for connecting an extension module
A hook for fixing a module to a base unit (One-touch installation)
A lever for mounting a module on a base unit
Description