Maintenance
4. Clean or replace each filter.
See figure.
5. Set the air filter and Titanium Apatite Photocatalytic
Air-Purifying Filter as they were and close the front
panel.
inside the indoor unit.
6. Wash the air filters with water or clean them with vacuum
cleaner.
thinned with lukewarm water, then dry them up in the shade.
Titanium Apatite Photocatalytic
3.3
Air-Purifying Filter
The Titanium Apatite Photocatalytic Air-Purifying Filter can be renewed by washing it with water
once every 6 months. We recommend replacing it once every 3 years.
Maintenance
1. Vacuum dusts, and soak in warm water or water for about 10 to 15 minutes if dirt is heavy.
2. Do not remove filter from frame when washing with water.
3. After washing, shake off remaining water and dry in the shade.
4. Since the material is made out of paper, do not wring out the filter when removing water from it.
Replacement
Remove the tabs on the filter frame and replace with a new filter.
NOTE
peration with dirty filters:
(1) cannot deodorize the air.
(3) results in poor heating or cooling. (4) may cause odour.
11
ff easily, wash them with neutral detergent
(2) cannot clean the air.
Specifications are subject to change without notice.
PERAT N NSTRUCT NS
Titanium Apatite
Photocatalytic
Air-Purifying
Filter
421 02 9260 00
Air filter