Daily Use - Electrolux EDP2074PDW User Manual

Adjusting the conductivity sensor
1. Use the programme knob to set any
programme.
2. Press and hold touchpads (A) and (B)
at the same time until one of the these
indicators comes on:
•
•

7. DAILY USE

Before you use the appliance for the
first time
1. Clean the appliance drum with a moist
cloth.
2. Start a short programme (e.g. 30 mi-
nutes) with moist laundry.
7.1 Starting a programme
without delay start
1. Prepare the laundry and load the ap-
pliance.
2. Set the correct programme and op-
tions for the type of load.
• The display shows the programme
duration.
3. Press the Start/Pause touchpad, the
programme starts.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance door
and the rubber seal.
7.2 Starting a programme
without delay start
1. Prepare the laundry and load the ap-
pliance.
2. Set the correct programme and op-
tions for the type of load.
• The display shows the programme
duration.
3. Press the Start/Pause touchpad, the
programme starts.
(low <300 μS/cm)
(moderate 300-600 μS/cm)
•
(high >600 μS/cm)
3. Press the touchpad (E) again and
again until the indicator of the correct
level comes on.
4. To confirm the adjustment, press and
hold touchpads (A) and (B) at the
same time for approximately 2 sec-
onds.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance door
and the rubber seal.
7.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
7.4 At the end of the
programme
When the programme is completed,
• An intermittent acoustic signal oper-
ates.
• The indicator
flashes.
• The indicator
comes on.
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is al-
most completed or completed.
When the crease guard phase is comple-
ted:
• The indicator
is on but does not flash.
• The indicator
goes off.
• Start/Pause indicator goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
ENGLISH 21
OFF
OFF