Setup And Operating Procedures; Battery Loading; Clock And Date Adjustment - Salter BPW-9100 Instructions And Guarantee

17. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
GB
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
18. This blood pressure monitor is verified by auscultatory method. It is recommended that you check annex B of ANSI/AAMI
SP-10:2002+A1:2003+A2:2006 for details of verification method if you need.

SETUP AND OPERATING PROCEDURES

Fully Automatic Electronic Blood Pressure Monitor is for use by medical professionals or at home and is a non-invasive
blood pressure measurement system intended to measure the diastolic and systolic blood pressures and pulse rate of an
adult individual by using a non-invasive technique in which an inflatable cuff is wrapped around the wrist.

1. BATTERY LOADING

a. Open battery cover at the back of the monitor.
b. Load two "AAA" size batteries. Please pay attention to polarity.
c. Close the battery cover.
When LCD shows battery symbol
Rechargeable batteries are not suitable for this monitor.
Remove the batteries if the monitor will not be used for a month or more to avoid relevant damage of battery leakage.
Avoid the battery fluid to get in your eyes. If it should get in your eyes, immediately rinse with plenty of clean water and
contact a physician.
The monitor, the batteries and the cuff, must be disposed of according to local regulations at the end of their usage.

2. CLOCK AND DATE ADJUSTMENT

a. Once you install the battery or turn off the monitor, it will enter Clock Mode, and LCD will display time and date by turns.
See picture 2&2-1.
b. While the monitor is in Clock Mode, pressing both the "START" and "MEM" button simultaneously, a beep is heard and the
month will blink at first. See picture 2-2. Press the button "START" repeatedly, the day, hour and minute will blink in turn.
While the number is blinking, press the button "MEM" to increase the number. Keep on pressing the button "MEM", the
number will increase fast.
c. You can turn off the monitor by pressing "START" button when the minute is blinking, then the time and date is
confirmed.
d. The monitor will turn off automatically after 1 minute of no operation, with the time and date unchanged.
e. Once you change the batteries, you should readjust the time and date.
, replace all batteries with new ones.
Picture 2 Picture 2-1 Picture 2-2
6