Displaying Stored Results; Deleting Measurements From The Memory - Salter BPW-9100 Instructions And Guarantee

7. DISPLAYING STORED RESULTS

GB
a. After measurement, you can review the results in the memory bank by pressing the "MEM" button. Alternatively, you can
press "MEM" button in Clock Mode to display the stored results. If it no result stored, LCD will show dashes as picture
7, while press the button "MEM" or "START", machine will turn off. If there are results in the memory bank, the LCD will
display the amount of the results in the memory bank. See picture 7-1.
b. And then, the most recent result will be displayed with date and time stamp. See picture 7-2. Followed by, the blood
pressure and pulse rate will be shown separately. Irregular heartbeat symbol (if any) will blink. See picture 7-3&7-4.
Press "MEM" button again to review the next result. See picture 7-5. In this way, repeatedly pressing the MEM button
displays the respective results measured previously.
c. When displaying the stored results, the monitor will turn off automatically after 1 minute of no operation. You can also
press the button "START" to turn off the monitor manually.

8. DELETING MEASUREMENTS FROM THE MEMORY

When any result is displaying, keeping on pressing button "MEM" for three seconds, all results in the current memory bank
will be deleted after three "beep". LCD will show picture 8, Press the button "MEM" or "START", the monitor will turn off.
Picture 7 Picture 7-1
Picture 7-3 Picture 7-4
Picture 8
Picture 7-2
Picture 7-5
8