Attach The Roll Unit; Attach The Basket; Turn On The Printer - Canon PRO-4000S Setup Manual

4
Place the printer on the stand such that the protrusion (A) for aligning
the position of the printer under the rear side of the printer is aligned
with the position of the black marker on the basket rod attached to
the supporting plate.
• If you are not using a stand, place the printer in the installation
location and proceed to "Turn On the Printer".
Important

Attach the Roll Unit

• Models That Use the Roll Unit
Attach the roll unit to the stand.
-> Refer to the Roll Unit Setup Guide (separate manual).
• Models That Do Not Use the Roll Unit
Proceed to "Attach the Basket".

Attach the Basket

• Models That Use a Stand
Attach the basket to the stand.
-> Refer to "Attach the Basket" in the Printer Stand Setup Guide (separate manual).
• Models That Do Not Use a Stand
Proceed to "Turn On the Printer".

Turn On the Printer

1
Open the top cover.
A
A
5
Affix the printer to the stand.
Remove the basket rod.
Use an M4 Allen wrench to securely affix by using three M4
hex screws each on the left and right from the bottom of the
supporting plate.
2
Pull up and remove the belt stopper (A).
• Keep the belt stopper you removed for future use. You
will need them in case you move the printer to another
Note
location.
• When you open the top cover, a cleaning brush is
stored on the right side. Take it out and use it when
cleaning inside the top cover.
4
A