Canon PRO-4000S Setup Manual page 10

Perform Print Head Adjustment and Select the Connection Method on the
PRO-2000
1
The paper starts feeding, and then the
printer automatically starts charging the
system with ink and adjusting the print
head. Charging the system with ink
and adjusting the print head for the first
time takes about 50 minutes and uses 5
sheets of paper for adjustment.
• Do not open the covers of the printer
or turn the power off while the ink is
Important
charging for the first time and the print
head adjustment is executing.
• Charging the system with ink fills the
system from the ink tanks to the print
Note
head. In addition, cleaning is performed
to keep the printer in optimal condition.
This may cause the remaining ink
indicator and maintenance cartridge
capacity indicator to drop some amount.
The starter ink tank is for first-time
installation. It is recommended that you
purchase replacement ink tanks quickly.
4
Once the print head adjustment has
finished, the screen below appears.
Tap the connection method to use.
Check the message about the connection
method and tap Yes if there are no
problems.
5
If you selected USB connection
Proceed to "Connect to the Printer" on
p.12.
If you selected Wireless LAN connection
To configure the wireless LAN settings using a computer, tap Yes, or to configure the wireless
LAN settings on the printer, tap No, and proceed to "Connect to the Printer" on p.12.
To load roll paper after setup, tap the paper settings display area from the home screen, then
instructions on the screen.
For details, refer to the Online Manual that can be accessed by the procedure in "How to Display the Online Manuals" (p.14).
2
Once a single sheet of the adjustment
pattern has finished printing, lift up the
release lever and remove the paper for
adjustment.
USB connection
This is the method for connecting the printer to a computer using a USB cable.
Only 1 printer can be connected.
Do not connect the USB cable yet.
Wired LAN connection
This is the method for connecting the printer to the network using a LAN cable.
Wireless LAN connection
This is the method for connecting the printer to the network without using a cable.
If you selected Wired LAN connection
Use the LAN cable to connect the
wired LAN connector on the back of
the printer to the hub port.
10
3
Load the next paper by referring to steps
2 to 5 on p.9. Print head adjustment uses
5 sheets of paper. Repeat steps 2 and 3
until the printing has finished.
Tap OK, and then proceed to "Connect
to the Printer" on p.12.
If you selected Do not connect
Setup has finished at this point.
However, the connection settings and
software installation will need to be
performed separately in order to use the
printer from a computer.
(Refer to "Connect to the Printer" on p.12)
(roll paper icon), then Replace paper, and follow the