Load The Paper - Canon PRO-4000S Setup Manual

Load the Paper

Load the paper for adjustment.
1
Tap OK.
Tap Manual.
3
Insert the paper for adjustment between
the platen (A) and paper retainer (B) in
portrait orientation with the printed side of
the paper facing up.
B
A
6
The screen for selecting the paper type
appears. Tap the type of paper you
loaded.
In this case, tap Coated papers then HW
Coated HG.
The remainder of this procedure differs depending on the model you are using.
Check the name of the model you are using, and proceed to the following page.
For the PRO-2000: Go to p.10
For the PRO-4000, PRO-4000S, and PRO-6000S: Go to p.11
2
Open the top cover and lift the release
lever.
4
Load the paper aligned with the paper
alignment lines (A) to ensure that the
paper is not crooked, and align the
leading edge of the paper with the front
side of the line (B).
• If The paper is loaded askew. appears,
repeat steps 2 to 5.
Note
9
• Do not touch the linear scale (A),
carriage shaft (B), or ink tube stabilizer
Important
(C). Touching them may cause damage.
5
Lower the release lever to lock the paper
and close the top cover.
B
A
C A
B