Xerox Phaser 7760 User Manual page 146

The power cord is attached to the printer as a plug-in device at the back of the printer. If it is
necessary to disconnect all electrical power from the printer, disconnect the power cord from
the electrical outlet.
Warning:
installing optional equipment and are specifically instructed to do so. Power should be OFF
when performing these installations. Except for user-installable options, there are no parts that
you can maintain or service behind these covers.
Note:
The following are hazards to your safety:
■
■
■
If any of these conditions occur, do the following:
1.
2.
3.
Laser Safety
With specific regard to lasers, this printer complies with laser product performance standards
set by governmental, national, and international agencies and is certified as a Class 1 Laser
Product. The printer does not emit hazardous light because the beam is totally enclosed during
all modes of customer operation and maintenance.
Maintenance Safety
■
■
■
Downloaded From ManualsPrinter.com Manuals
Do not remove the covers or guards that are fastened with screws unless you are
Leave the printer on for optimum performance; it does not pose a safety hazard.
The power cord is damaged or frayed.
Liquid is spilled into the printer.
The printer is exposed to water.
Turn off the printer immediately.
Disconnect the power cord from the electrical outlet.
Call an authorized service representative.
Do not attempt any maintenance procedure that is not specifically described in the
documentation supplied with your printer.
Do not use aerosol cleaners. The use of supplies that are not approved may cause poor
performance and could create a hazardous condition.
Do not attempt to open, reuse, or burn any consumables or routine maintenance items. For
information on Xerox supplies recycling programs, go to www.xerox.com/gwa.
Phaser® 7760 Color Laser Printer
A-2