Test Symbols; Appliance Description ������������������������������������� 30 13. Troubleshooting; Settings - STIEBEL ELTRON DNM 3 Operation And Installation

OPERATION
Appliance description
2.3

Test symbols

See type plate on the appliance.
Country-specific approvals and certifications: Germany
In line with [German] State Building Regulations, a general test
certificate has been issued for these appliances, as verification of
their suitability regarding noise emissions.
DIN 4109
P-IX 6744/I
30 | DNM
3. Appliance description
The hydraulically controlled, non-pressurised mini instantaneous
water heater heats the water directly at the draw-off point. The
heating system starts automatically when the tap is opened. The
short pipe runs ensure that energy and water losses are minimal.
The DHW output depends on the cold water temperature, the heat-
ing output and the flow rate.
The bare wire heating system is suitable for hard and soft water
areas. This heating system has a low susceptibility to scale build-
up. The heating system ensures quick and efficient DHW provision
at the hand washbasin.
Fitting the special aerator supplied provides an optimum water jet.
4.

Settings

The appliance heating system switches on automatically as soon
as you open the DHW valve at the tap or activate the sensor of a
sensor tap. The water is heated. The water temperature can be
adjusted at the tap:
For the start volume, see chapter "Specification / Data table / On".
www.stiebel-eltron.com