Installation Precautions - HP PS1810-8G Installation And Getting Started Manual

W A R N I N G S
C a u t i o n s

Installation precautions

Follow these precautions when installing the switch.
When you mount PS1810-8G Switch under HP ProLiant MicroServer
■
Gen8s, do not stack more than two servers on top of the switch.
Before you mount the PS1810-24G Switch in a rack or cabinet, ensure the
■
rack or cabinet is adequately secured to prevent it from becoming unstable
and falling over.
Devices installed in a rack or cabinet must be mounted as low as possible,
with the heaviest devices at the bottom and progressively lighter devices
installed at the top.
When you mount the switch on the wall, ensure that the network ports are
■
facing up or down to meet national and international safety requirements.
The side vents cannot be placed facing up or down.
When installing the switch, ensure that the AC outlet is located near the switch
■
and is easily accessible in case the switch must be powered off.
Ensure that the AC power source circuits are properly grounded.
■
Use only the AC/DC power adapter and power cord (if applicable), supplied
■
with the switch. Use of other adapters or power cords, including those that came
with other HP Networking products, might result in damage to the equipment.
For those switches that use a power cord, if your installation requires a different
power cord than the one supplied with the switch, be sure to use a power chord
that has the symbol of the safety agency that defines the regulations for power
cords in your country. The mark is your assurance that the power cord can be
used safely with the switch.
Ensure the switch does not overload the power circuits, wiring, and over-current
■
protection. To determine the possibility of overloading the supply circuits, add
together the ampere ratings of all the devices installed on the same circuit as
the switch and compare the total with the rating limit for the circuit. The
maximum ampere ratings are usually indicated on the devices near the AC
power connectors.
Do not install the switch in an environment where the operating ambient
■
temperature might exceed 40C (104 F).
Ensure the air flow around the sides of the switch is not restricted.
■
Installing the switch
Included parts
2-3