B-540-Ext-330-Rs-Ipw Receiver - Binary B-540-EXT-330-RS-IPW Installation Manual

4.2. B-540-EXT-330-RS-IPW Receiver

A
B
C
D
A. HDMI Out
HDMI Output to connect to the HDMI input of a sink(display)
B. IR Receiver
IR input to connect to IR Receiver or to output of a control system
C. IR Flasher
IR output to connect to IR Flasher
D. IR Flasher level
Adjusts the intensity of the IR Flasher output
E. HDBT Link LED
Lights up green when synced with receiver
F. HDCP LED
Lights up green when HDCP link has been established; Blinks when content does not
require HDCP; Off when no HDMI signal is recognized
G. HDBT HPD LED
Lights up green when Hot Plug event is Detected
H. Power LED
Lights up blue when the unit has power
I. Thread-locking Power Connector
Connect to an optional 12V DC, 2A power supply (B-PS-12VDC-2A)
J. Ethernet (RJ45)
To communicate IP data between Transmitter and Receiver
K. RS-232
To communicate RS-232 command with the transmitter when connected to a control
system
L. DIP Switches
IR RCVR PWR OFF/ON
OFF to connect to control system | ON to connect to IR Receiver
DCE/DTE
To select if serial (RS232) communication via DB-9 is in DTE or DCE mode
SERVICE /LINK (RS-232)
SERVICE for firmware operation | LINK for passthrough (normal) operation
Front
FIGURE 2: Receiver Layout
6
M N
Back