Optional Remote Power (Receiver Only) - Binary B-540-EXT-330-RS-IPW Installation Manual

6.6. Optional Remote Power (Receiver Only)

CAUTION: DO NOT connect the power supply to the device until it is completely
installed and all connections have been made.
Power for the B-540-EXT-330-RS-IPW receiver can be supplied via a remote power source
when use of either PoC or the Latch-Locking Power Jack is not desired. The connection is a 2
conductor removable plug located on the rear of the B-540-EXT-330-RS-IPW receiver. The
recommended cabling is one 18 gauge per leg or two 22/ 24 gauge per leg.
Observe the connections polarity markings. Reversing the polarity may cause damage to the
product.
+(POS)
-(GND)
FIGURE 15: Remote Power Pin Out
The included WPS-ACC-PWR-DC Power Plug can be used to convert the single plug of a power
supply to 2 wires. This eliminates the need to cut the wires on the end of a power supply.
FIGURE 16: Power Plug
14