Installing The A1000 Controller Canister - Sun Microsystems StorEdge D1000 Upgrade Installation Manual

Removing the Canister
FIGURE 2

Installing the A1000 Controller Canister

1. Check whether you have a version of RM6 installed.
If have a version of RM6 installed on your host and it is not RM6.1.1, prepare to
install the new software before you turn on the power to your newly installed Sun
StorEdge A1000.
2. Slide the Sun StorEdge A1000 canister into the slot in the chassis.
Note – Be sure to hold the canister in a level position when sliding it into the slot.
The top of the canister has rails that fit into guide hooks in the chassis.
3. Push firmly until the controller board connector engages.
4. Push both handles inward until they are flush with the canister.
5. Connect all power cables, SCSI cables, and install a terminator, if necessary.
See the Sun StorEdge A1000 and D1000 Installation, Operations, and Service Manual and
the Sun StorEdge A1000 and D1000 Product Note for more information.
Sun StorEdge D1000 to A1000 Upgrade Installation 3