Slowly remove the power block. The signal and power cables are still attached.
9.
While supporting the power block, disconnect the signal and power cables on each side of the power
10.
block.
To replace the component, reverse the removal procedure.
Hard drive drawer
To remove the component:
Power down the D6000
1.
Disconnect all cables.
2.
Remove all power supplies
3.
Remove all fan modules ("Fan" on page 24).
4.
Remove all hard drives
5.
("Power
down" on page 21).
("Power
supply" on page 27).
("Hard
drive" on page 23).
Removal and replacement procedures 31