Power Supply - HP D6000 Disk Enclosure Maintenance And Service Manual

Remove the component as indicated.
To replace the component, reverse the removal procedure. Be sure the I/O module blank is fully seated and
the I/O module blank handle is in the locked position.

Power supply

Before removing the component, be sure to do the following:
•
Verify the status of the power supply to be replaced by reviewing rear panel LEDs and buttons (on page
46).
•
Be sure that your configuration can support your actions. If the proper redundancy is not in place,
power down the D6000 before beginning this procedure.
To remove the component:
Disconnect the AC power cord.
1.
Removal and replacement procedures 27