Remove the hard drive.
2.
To replace the component:
Fully extend the hard drive lever.
1.
Push the hard drive all the way into the drive bay, and then close the lever.
2.
Fan
IMPORTANT:
power cord label, require that the power cord be removed before removing a fan.
Before removing a fan, do the following:
•
Verify the status of the fan to be replaced by reviewing rear panel LEDs and buttons (on page 46).
•
Be sure that your configuration can support your actions. If the proper redundancy is not in place,
power down the D6000 before beginning this procedure.
To remove the component:
Be sure that the hard drive drawer is closed.
1.
Configurations using power cord part number 142263-004, located on the
Removal and replacement procedures 24