Preparing The Installation; Electrical And Water Connection - Fhiaba Integrated 599 Series Installation Manual

Preparing the installation

Transport to installation site and unpacking
The appliance is very heavy.
Take maximum care during handling to avoid injury.
The appliance should always be transported in an erect
position.
Avoid at all costs leaning it on its front side.
2
4
1
1
3
Since this is a large and heavy appliance, before trans-
porting the appliance, check the access to the location
where it will be installed (door size, manoeuvring space in
stairwells, etc.).
The appliance is attached to the base of the packaging
(pallet) through four bolts which can be removed using a
17 mm (3/4") wrench.
It is recommended to use a manual transporting device to
move the appliance to the installation site, and only at this
point to remove the base of the packaging.
The appliance should always be transported in an erect
position.
If this is not possible, transport the appliance laying on its
rear side.
Once at the installation site, the appliance, which is
equipped with four wheels, can be taken off the pallet and
positioned in the installation area.
Operate as follows:
Take off the four bolts
1
pallet by means of a 17 mm (3/4") open spanner.
Remove the fixing brackets
To remove the front fixing bracket
for one or two turns the rear wheel adjusting bolt
by means of a 13 mm (1/2") box spanner, avoiding
too much strenght while thightening the nut, which
could damage the leveling
From the back of the unit and by means of a suitable,
high duty hand trolley, take off the appliance and place
it on the floor.
Be very careful to avoid any damage to floors. Delicate floors
should be protected with plywood, hard cardboard or similar
material panels.
securing the appliance to the
and .
3 4
, unscrew
3
feet adjusting system.

Electrical and Water connection

The Built-in Fhiaba filter cannot make it safe to drink any
water which is not suitable for human consumption.
The appliance should be connected only to a drinkable
water supply system.
Do not use extension cords or adapters.
Once the appliance has been connected to the water system,
turn the Ice Maker off (touch the button
switch it off) before the main water is shut off.
W E
A Schuko 16 A socket with an efficient grounding should
be made available for the electrical mains connection, as
well as an omnipolar
switch which can easily be reached when the appliance
is installed.
To connect to the water supply system (for appliances
equipped with ice makers) a tap with a male 3/4" connec-
tion should be provided, which must also be easily acces-
sible once the appliance is installed.
The appliance is provided with a water supply hose and
seal kit which is suitable for high water pressure and com-
plies the Food Regulations.
The water filter cartridge, which is provided with the appli-
ance, should be installed according to the accompanying
instructions.
Use only the new hose and the new gaskets which are sup-
2
plied with the appliance. Discard any hose and gasket
which may have already been installed.
Electrical cord length: 2,0 mt (78 3/4")
Water connection line length: 2,5 mt (98 3/8")
www.fhiaba.com · info@fhiaba.com · Tel +39 (0)434 420160 · Fax +39 (0)434 420161
Installation Guide
on control panel to
E W E W
W
EN
E
43