Table of Contents
Advertisement
2. INSTALLATION
2.1. Installation
Make sure that installation is performed correctly,
adhering to all of the instructions in the specific in-
stallation guide provided with the appliance.
Warning
If any model has water connections, make
them before connecting the machine to the
electrical system.
> The appliance must be connected to ground in
compliance with electrical system safety standards.
> Position the appliance with the aid of a second
person.
> Never use the open door to lever the appliance
into position.
> Avoid exerting too much pressure on the door
when open.
> The appliance must not be installed near heat
sources. If this is not possible, suitable insulation
must be used.
> The appliance must not be exposed to direct sun-
light.
> Do not use the appliance outdoors.
> Installation and servicing should be carried out
by qualified personnel in compliance with current
standards.
> Ensure that an authorised technician performs
the electrical connection.
> If the power supply cable is damaged, to avoid any
danger, contact technical support immediately and
they will replace it, so as to prevent any risk.
> Always put on the necessary Personal Protective
Equipment (PPE) before performing any work on the
appliance (installation, maintenance, positioning or
handling).
> Before performing any operation involving the ap-
pliance, switch off the power supply.
> If installed near another refrigerator, refer to the
installation guide.
> Do not try to repair the appliance yourself or with-
out the assistance of a qualified technician.
> Do not install/use the appliance outdoors.
> WARNING: Make sure that the power supply cable
does not become caught or damaged when position-
ing the appliance.
> To prevent instability of the appliance, install and
secure it correctly as indicated in the instructions
provided in this manual.
> This device can be used up to a maximum height
of 2000 meters above sea level.
8
www.fhiaba.com · sales@fhiaba.com · Info Line 800-344222
2.2. Connection to the water system
Models equipped with an Ice Maker require a connec-
tion to the domestic water supply system.
It must be carried out using only the supplied new
water inlet hose with ¾" thread (do not use or reuse
previously used pipes).
The system pressure must be between 0.05 MPa and
0.5 MPa (between 0.5 bar and 5 bar).
Any pressure outside of this range may cause the
water system to malfunction or leak.
Important
Do not use extension cords and/or multiple
adapters for connection.
Warning
Make sure that installation is performed
correctly and in accordance with all of the
instructions in the specific installation man-
ual provided with the appliance.
Warning
Do not attempt to use a locally-sourced
threaded garden hose adapter or braided
supply line. It will strip the threads on the
appliance's water connection solenoid.
Advertisement
Table of Contents
