Mounting The Handles - Fhiaba Integrated 599 Series Installation Manual

Mounting the handles

Handles will have to be mounted on the panels before
they are applied to the fridge.
Operate as follows:
Drill two holes on the back of the panels according to
the table below .
1
1
Place the handle on top of the holes and insert the
screws through the panel and into the handle support
.
2
Handle product code
HV
794 mm (31
Lenght 1104 mm (43
A
1/2")
Distance
900 mm (35 480 mm (18
between
1/2")
fixing points X
899
749
Series
599
HO8 HO7 HO5
644 mm (25 494 mm (19
1/4") 3/8") 5/8")
340 mm (13
490 mm (19
3/8")
7/8") 1/4")
899 749 599
Mounting panels to the door and the drawer
Once all brackets and small brackets have been applied
to the panels, you can begin installing the bottom drawer.
Operate as follows:
Partially tighten the screw to the fixing
1
Hook the bottom drawer panel starting from the fixings
on the bottom .
2
2
2
It is now possible to align panels to adjacent cabinets in
height using the lower alignment brackets,
or untightening the screws into position as needed. With
the screw slighty tightened, move the panel sideways to
align it to the other panels on the unit or other adjacent
structures.
3
Depth alignment: working from the inside of the drawer,
after lifting up the magnetic seal, adjust the panel position
so it is closer to or further away from the door using the
holes and then secure the panel using the holes
4
www.fhiaba.com · info@fhiaba.com · Tel +39 (0)434 420160 · Fax +39 (0)434 420161
Installation Guide
EN
.
1
tightening
3
.
5
57