All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by WEP/WS 1065 BU TV Consumer Care, the Netherlands...
EN 2 TPM4.1E LA Revision List 1. Revision List Manual xxxx xxx xxxx.0 • First release. Manual xxxx xxx xxxx.1 • Added “/60” models to Table 6-3. Manual xxxx xxx xxxx.2 • Chapter 4: added information on returning a defect LCD panel.
Page 3
Technical Specifications, Connections TPM4.1E LA EN 3 Connections 18870_001_100107.eps 100308 Figure 2-1 Connection overview Note: The following connector colour abbreviations are used 15 - DDC_SCL DDC clock (acc. to DIN/IEC 757): Bk= Black, Bu= Blue, Gn= Green, 16 - DDC_SDA DDC data Gy= Grey, Rd= Red, Wh= White, Ye= Yellow.
Page 4
EN 4 TPM4.1E LA Technical Specifications, Connections 6 - EXT1 - 2: Video RGB/YC - In, CVBS - In/Out, Audio - Wh - Audio - L 0.5 V / 10 kW In/Out Rd - Audio - R 0.5 V / 10 kW...
3.3.3 Spare Parts external damage. • Check the strain relief of the Mains/AC Power cord for For the latest spare part overview, consult your Philips Spare proper function. Part web portal. • Check the electrical DC resistance between the Mains/AC...
Page 6
EN 6 TPM4.1E LA Precautions, Notes, and Abbreviation List The third digit in the serial number (example: Abbreviation List AG2B0335000001) indicates the number of the alternative B.O.M. (Bill Of Materials) that has been used for producing the 0/6/12 SCART switch control signal on A/V specific TV set.
Page 7
Precautions, Notes, and Abbreviation List TPM4.1E LA EN 7 Directions For Use: owner's manual SDI), is a digitized video format used Digital Media Reader: card reader for broadcast grade video. DMSD Digital Multi Standard Decoding Uncompressed digital component or Digital Natural Motion digital composite signals can be used.
Page 8
SOPS Self Oscillating Power Supply Serial Peripheral Interface bus; a 4- wire synchronous serial data link standard S/PDIF Sony Philips Digital InterFace SRAM Static RAM Service Reference Protocol Small Signal Board Spread Spectrum Clocking, used to reduce the effects of EMI...
Mechanical Instructions TPM4.1E LA EN 9 4. Mechanical Instructions Index of this chapter: Notes: 4.1 Cable Dressing • Figures below can deviate slightly from the actual situation, 4.2 Service Positions due to the different set executions. 4.3 Assy/Panel Removal 32"...
Page 10
EN 10 TPM4.1E LA Mechanical Instructions 18870_100_100107.eps 100308 Figure 4-2 Cable dressing (42") Service Positions 5. Take out the SSB together with its shielding. 6. Remove the screws near the HDMI and L/R audio connectors. For easy servicing of a TV set, the set should be put face down 7.
Page 11
Mechanical Instructions TPM4.1E LA EN 11 4.3.4 Stand removal 5. Remove the bezel from the set. 6. Unplug the connectors from the IR/LED board. 7. See Figure 4-4, unplug the connector [1] from the Figure 4-3. Keyboard Control Panel. Caution: it is mandatory to remount all different screws at their 8.
Page 12
EN 12 TPM4.1E LA Mechanical Instructions 4.4.3 Power Supply Unit (PSU) 4. Remove the clips that secure the LCD panel with the bezel. 5. Remove the fixation screws that secure the LCD panel with the bezel. Caution: it is mandatory to remount all different screws at their 6.
Page 13
Mechanical Instructions TPM4.1E LA EN 13 Set Re-assembly To re-assemble the whole set, execute all processes in reverse order. Notes: • While re-assembling, make sure that all cables are placed and connected in their original position. Figure 4-1 Figure 4-2.
EN 14 TPM4.1E LA Service Modes, Error Codes, and Fault Finding 5. Service Modes, Error Codes, and Fault Finding Index of this chapter: 5.1 Service Modes 5.2 Service Tools 5.3 Software Upgrading 5.4 Error Codes 5.5 Fault Finding and Repair Tips...
Page 15
Introduction The ComPair II interface box is connected to the PC via an ComPair (Computer Aided Repair) is a Service tool for Philips USB cable. For the TV chassis, the ComPair interface box and Consumer Electronics products. and offers the following:...
Page 16
Software Upgrading 5.3.1 Introduction 18870_203_100209.eps Philips continuously tries to improve its products, and we 100209 recommend that you update the TV software when updates are Figure 5-6 Update the TV software [1/6] available. Software update files can be obtained from your dealer or can be downloaded from the following websites: http://www.philips.com/support...
Service Modes, Error Codes, and Fault Finding TPM4.1E LA EN 17 18870_204_100209.eps 18870_208_100209.eps 100209 100209 Figure 5-7 Update the TV software [2/6] Figure 5-11 Update the TV software [6/6] Notes: • Do not remove the USB flash drive during the software update.
EN 18 TPM4.1E LA Alignments 6. Alignments Index of this chapter: values. This is the next best solution. The default values are 6.1 General Alignment Conditions average values coming from production. 6.2 Hardware Alignments • Select a COLOUR TEMPERATURE (e.g. COOL, 6.3 TV Mode display adjust...
Alignments TPM4.1E LA EN 19 6.5.2 V-com adjustment Press Remote control “147852+info” Key, or press “062596+Info” for TV V-com adjustment, enter the V-com adjustment mode with a pattern (Green 2) as shown in Figure 6-2. Row 1 Row 2 Row 3...
TPM4.1E LA Circuit Descriptions 7. Circuit Descriptions Index of this chapter: Introduction 7.1 Introduction 7.2 Power Architecture The TPM4.1E LA chassis is using the MT8222 for main 7.3 T-CON Architecture processing. Notes: 7.1.1 Implementation • Only new circuits (circuits that are not published recently) are described.
Page 21
Circuit Descriptions TPM4.1E LA EN 21 7.1.3 SSB Cell Layout DC - DC CONVERSION TUNER ANALOG I/O SERVICE CONNECTOR TCON DIGITAL I/O MTK8222 AUDIO CLASS - D 18870_200_100204.eps 100308 Figure 7-2 SSB layout cells (top view) 2010-Jun-18...
Page 22
AUD_PWR_SW AMP_EN U6202 18870_404_100211.eps 100308 Figure 7-3 Power Architecture TPM4.1E LA platform 7.2.1 Power Supply Unit 1. +5V: It will transform 3.3V, DV 1.0V,5V on. 2. 3.3V: it can’t be controlled by MCU. It transform AV1.2 V for analog core power.
Page 23
Panel Vcc DC to DC (VGH/VDD/VCC/VGL) 18870_404_100211.eps 100308 Figure 7-4 T-CON Architecture TPM4.1E platform 7.3.1 T-CON Unit The T-CON section includes the T-CON IC, a Level shift IC, a DC to DC conversion IC and a correction Gamma IC. The T-CON IC will transform the LVDS signal into a mini-LVDS signal with a 6 pairs Level shifter IC.
EN 24 TPM4.1E LA IC Data Sheets 8. IC Data Sheets This section shows the internal block diagrams and pin configurations of ICs that are drawn as “black boxes” in the electrical diagrams (with the exception of “memory” and “logic”...
Page 25
IC Data Sheets TPM4.1E LA EN 25 Pinning information 18870_301_100211.eps 100305 Figure 8-2 Pin configuration 2010-Jun-18...
Block Diagrams TPM4.1E LA EN 31 Block Diagram 24C02 TV_CVBS (CVBS 0P) 24C32 24C02 DVI EDID DSUB EDID NVRAM MM Tuner SIF_P WT6703 SPI Flash STDBY MCU ROM / 4M HDMI 1 HDMI 2 RP,GP,BP D-SUB Side AV CVBS1P Side S -Video...
Styling Sheets TPM4.1E LA EN 63 11. Styling Sheets Styling Sheet 32" DALI 32" Pos No. Description Remarks FRONT CABINET REAR COVER STAND ASSY STAND NECK 1176 REMOTE CONTROL FOR ELECTRICAL PARTS/ASSEMBLIES SEE WIRING DIAGRAM CHAPTER 9 18850_800_100309.eps 100309 2010-May-12...
Styling Sheets TPM4.1E LA EN 64 Styling Sheet 42" DALI 42" Pos No. Description Remarks FRONT CABINET REAR COVER STAND ASSY STAND NECK 1176 REMOTE CONTROL FOR ELECTRICAL PARTS/ASSEMBLIES SEE WIRING DIAGRAM CHAPTER 9 18850_801_100309.eps 100309 2010-May-12...