Enabling And Disabling Rear Parksense - Jeep Renegade 2016 Owner's Manual

If an obstacle is detected in the left and/or right rear
region, the display will show a single flashing arc in the
left and/or right rear region and will produce a fast
sound tone. As the vehicle moves closer to the obstacle,
the display will show the single arc moving closer to the
vehicle and the tone will change from fast to continuous.
In general, the car is closest to the obstacle when the
display shows only a flashing arc and the chime becomes
continuous.
The color on the display depends on the distance and
location of the obstacle.

Enabling And Disabling Rear ParkSense

Rear ParkSense can be enabled and disabled with the
Rear ParkSense switch.
When the Rear ParkSense switch is pressed to
disable the system, the instrument cluster will
display the "PARKSENSE DISABLED" message for ap-
proximately five seconds. Refer to "Electronic Vehicle
Information Center (EVIC)" or "Driver Information Dis-
play (DID)" in "Getting To Know Your Instrument Clus-
ter" for further information. When the shift lever is
moved to REVERSE and the system is disabled, the
EVIC/DID will display the "PARKSENSE DISABLED"
message for as long as the vehicle is in REVERSE.
The Rear ParkSense switch LED will be ON when Rear
ParkSense is disabled or requires service. The Rear
ParkSense switch LED will be OFF when the system is
enabled. If the Rear ParkSense switch is pushed, and
requires service, the Rear ParkSense switch LED will
blink momentarily, and then the LED will be ON.
Rear ParkSense will remember the previous state when
the vehicle is switch off.
STARTING AND OPERATING 379
7