Jeep Renegade 2016 Owner's Manual page 629

Blind Spot Monitor (BSM) system is deactivated. To
change the Blind Spot Alert status, press the "Blind Spot
Alert" button and select from "Off," "Lights" or "Lights
& Chimes."
NOTE: If your vehicle has experienced any damage in
the area where the sensor is located, even if the fascia is
not damaged, the sensor may have become misaligned.
Take your vehicle to an authorized dealer to verify sensor
alignment. A sensor that is misaligned will result in the
BSM not operating to specification.
• ParkView Backup Camera Active Guidelines — If
Equipped
Your vehicle may be equipped with the ParkView Rear
Back Up Camera Active Guidelines that allows you to see
active guidelines over the ParkView Back up camera
display whenever the shift lever/gear selector is put into
REVERSE. The image will be displayed on the radio
touchscreen display along with a caution note to "check
entire surroundings" across the top of the screen. After
five seconds, this note will disappear. To change the
Active Guideline Status, press the "Active Guidelines"
button and select the "On" or "Off" button.
• ParkView Backup Camera Delay
When the vehicle is shifted out of REVERSE (with camera
delay turned OFF), the rear camera mode is exited and
the navigation or audio screen appears again. When the
vehicle is shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic grid lines
will be displayed for up to 10 seconds after shifting out of
"REVERSE" unless the forward vehicle speed exceeds
8 mph (12 km/h), the transmission is shifted into PARK
or the ignition is switched to the OFF position. To set the
ParkView Backup Camera Delay press the "MORE"
button on the faceplate, the "settings" button on the
touchscreen, then the "Safety & Driving Assistance"
MULTIMEDIA 627
11