Enabling And Disabling Rear Parksense - Jeep RENEGADE 2016 User Manual

OPERATING YOUR VEHICLE
Detection Distances
If the sensors detect more obstacles, it is taken into account only what is the shorter
distance.
Instrument Cluster Display
Rear ParkSense is displayed on the instrument cluster only if you have selected the
item "beep and display" inside the "Settings" menu of the Uconnect system.
If an obstacle is detected in the center rear region, the display will show a single solid
arc in the center rear region and will produce a one-half second tone. As the vehicle
moves closer to the obstacle, the display will show the single arc moving closer to the
vehicle and the sound tone will change from slow, to fast, to continuous.
If an obstacle is detected in the left and/or right rear region, the display will show a
single flashing arc in the left and/or right rear region and will produce a fast sound
tone. As the vehicle moves closer to the obstacle, the display will show the single arc
moving closer to the vehicle and the tone will change from fast to continuous.
In general, the car is closest to the obstacle when the display shows only a flashing
arc and the chime becomes continuous.
The color on the display depends on the distance and location of the obstacle.

Enabling And Disabling Rear ParkSense

Rear ParkSense can be enabled and disabled with the Rear ParkSense switch.
When the Rear ParkSense switch is pressed to disable the system, the instrument
cluster will display the "PARKSENSE DISABLED" message for approximately five
seconds. Refer to "Electronic Vehicle Information Center (EVIC)" or "Driver Infor-
mation Display (DID)" in "Getting To Know Your Instrument Cluster" in your owner's
manual on the DVD for further information. When the shift lever is moved to
REVERSE and the system is disabled, the EVIC/DID will display the "PARKSENSE
DISABLED" message for as long as the vehicle is in REVERSE.
The Rear ParkSense switch LED will be ON when Rear ParkSense is disabled or
requires service. The Rear ParkSense switch LED will be OFF when the system is
enabled. If the Rear ParkSense switch is pushed, and requires service, the Rear
ParkSense switch LED will blink momentarily, and then the LED will be ON.
Rear ParkSense will remember the previous state when the vehicle is switch off.
After turning off the ignition, the Rear ParkSense remains in this setting until the
next key cycle, even in the case of changing the setting of starting MAR/RUN to
STOP/OFF and then again in MAR/RUN.
CAUTION!
65