Filling The Water Tank - Homemaker LB-FS-40 User Manual

4 Filling the Water Tank

Warning: Unplug the appliance during filling and cleaning.
• To Fill the Water Tank, turn it upside down to access the filer cap.
Unscrew the filler cap and lift it up to remove. Note the filler cap is tight so as to
•
prevent any water leaks. If need be, use a towel to grasp the cap and twist
anticlockwise to unlock.
• Fill the tank through the filler hole until the water level is within a few millimetres
from the filling hole.
• Refit the filler cap and turn clockwise to lock in place. Important: Ensure the filler
cap is fully rotated and locked in place.
DO NOT fill with any other liquid than clean fresh
cold water.
DO NOT add any additives to the water.
NOTE: There is a Valve in the filler cap which
releases the water when placed back on to the
Misting Generator. Do not tamper with this valve.
• Place the Water Tank back on top of the Misting Generator.
Note: The carry handle on the water tank goes towards the back.
Caution:
If water is spilt on the floor, immediately wipe it up and dry the floor so as to
prevent any injury from slipping over etc.
Page 12 of 16