3.2 Fan Head / Controller Assembly
•
Take the Fan Head / Controller assembly and unscrew the two thumb screws
located on the back. Do not fully unscrew otherwise the two nuts will fall off.
•
Locate the two holes on the underneath of the Fan Head / Controller assembly onto
the two posts and push down until it stops.
•
Tighten the two Thumb Screws until they are secure.
3.3 Fan Blade and Safety Grille
•
Place the Back Grille over the threaded section on the Fan Head, ensuring the wire
handle on the back of the grille it at the top.
•
Take the plastic nut and screw on to secure the grille
Page 8 of 16