Specifications; Special Features - iCharger 106B+ User Manual

iCharger Synchronous Balance Charger/Discharger
Thank you for purchasing one of the iCharger series. Please read the entire User's Manual completely and
attentively as it contains a wide variety of specific programming and safety information.

Specifications

Input voltage range:
Charge current range:
Discharge current range:
Maximum charge power capacity:
Maximum discharge power capacity:
Maximum extern discharge power capacity:
Current drain for balancing:
Balance accuracy:
Lithium (LiPo/LiIo/LiFe) battery cell count:
NiCd/NiMH battery cell count:
Pb battery cell count:
Battery setup memories:
Intelligent temperature control:
PC Connect:
Weight:
Dimensions (L X W X D):

Special features

High power, high current, high-performance power conversion circuit. The iCharger series uses

advanced Synchronous buck-boost DC/DC converter technology with an output conversion efficiency
that can reach over 90%. This not only saves power and reduces heat build up but also makes the
charger more compact and conveniently mobile.
 Two input power choices: DC jack with auto-resetting fuse (maximum input current 6A) and butt-welded
alligator clips with 4mm bullet connectors (25A).The output power can be adjusted to align with the
available input power, thus preventting input current overload and protecting the DC source.
The iCharger series can be used with three types of Lithium batteries - LiPo, Lilo, LiFe - and has a fully

integrated cell balancer.
 Internal temperature sensor and temperature controlled automatic cooling FAN controls the internal
temperature and provides intelligent protection. When the internal temperature is over 60℃(140
output power is automatically reduced by 25%. If the temperature exceeds 65℃(149
is stopped.
 Convenient set of 10 battery profile memories that can be saved and loaded by number.
 2x16 backlit LCD screen that provides rich information including active mode, current, voltage, total
charge (mAh), charging time and temperature etc.
 Various charging/discharging settings and cycles to meet a wide range of customer needs. For Lithium
batteries: balance charging, normal charging, fast charging, storage, discharging, ext-discharging,
charge/discharge cycling, and battery monitoring. For NiCd/NiMH batteries: charging-auto,
charging-manual, discharging, charge/discharge cycling and forming charge. For Pb batteries: charging
and discharging.
Unique Lithium battery expanding discharge program. When you connect the external capacity

resistance, you can use it as the maximum discharge power capacity—170W (@25V/7A).
 Unique Lithium battery Monitor program. When you use other equipment to charge or discharge a
Lithium pack, you can use the iCharger to monitor the per-cell voltages, battery temperature and
process time. If any individual cell appears over-charged or over-discharged or the pack is too hot or the
process has gone on for too long, the iCharger will generate an alarm sound and the related information
will blink.
 Electric motor test mode can be used to run-in electric motors, test motor parameters and performance,
check tolerances etc.
106B+
10.0 – 18.0VDC
0.05 – 10.0A
0.05 – 7.0A
250W @ input voltage > 13.5V
20W
170W @ 25V/7A
<300mA
<10mV
1 – 6 series (In non-balance mode, expand LiFe to 8s)
1 – 17 series
1 – 12 series (2 – 24V)
10
Yes
USB port
350g
134X83X25mm
5.28‖X3.27‖X0.98‖
-3-
106B+
o
F), the
o
F) the charge cycle