4010Duo Special Features; Appearance Parameters; Specifications - iCharger 4010DUO User Manual

iCharger Synchronous Balance Charger/Discharger
transfer, sub-license, as well as other acts of infringement of software copyright is strictly prohibited, but apart from
the restrictions prohibited by applicable law.
 4010DUO Special Features
1. The 4010DUO uses advanced Synchronous buck-boost DC/DC converter technology, high power, a high current
and high-performance power conversion circuit. The maximum charge power capacity is up to 2000W, the
maximum charge/discharge current of a channel is up to 40A, and two channels in Synchronous Mode are up to
70A.
2. Channel Supports 10s LiPo, Lilo, LiFe, NiZn, with maximum 1.2A balance current, and adopts a unique balance
calculation of internal resistance correction.
3. Intelligent fan control. Sensing internal temperature via the internal temperature sensor, to thereby control the fan
speed.
4. When the channel output connects the battery after the charger powers on, it will start automatically the
anti-sparking protection (the chargers with V2.05 above firmware version) .
5. Internal temperature protection. When the internal temperature exceeds the Power Reduce temperature, the output
power is automatically reduced; and the charger will shut down when temperature exceeds the Shut-down
temperature.
6. This charger can save 64 parameters sets and support the data import/export to SD card.
7. A 2.8-inch LCD screen provides rich information including current, voltage, power, capacity, internal resistance,
control status, time-consuming and temperature, etc.
8. Multi-discharge features: self-discharge, regenerative to input discharge, regenerative to channel discharge, and
lithium battery extra expanding discharge.
9. Supports measurement for internal resistance of battery offline and online. Can measure not only the internal
resistance of the entire battery pack, but also measure the internal resistance of each cell within the lithium battery.
10. The iCharger has protection for reversed polarity (input or output), input voltage/current, battery temperature,
charging capacity, overrun time and maximum power etc.
11. Supports upgrading the hardware program by USB port. The iCharger also supports the "Logview" software and
can display, plot and analyze the charge and discharge data by it. (See detail information about Logview at the
following website: http://www.logview.info)
 Appearance Parameters
Net weight:
Dimension:
 Specifications
Input voltage range:
Maximum input current limit:
Maximum charge/discharge current:
Maximum charge power capacity:
Maximum discharge power capacity:
Maximum regenerative discharge power capacity:
Maximum extra discharge power capacity:
Maximum current drain for balancing:
1.47kg
210.0× 140.1× 80.2 ± 0.5mm
9.0—50.0VDC
<65A
70A@Syn. Mode
2000W (Channel 1400W @input > 23.5V)
200W (Channel 130W)
2000W (Channel 1400W)
3200W (Channel 1600W @40V/40A)
2.4A@Syn. Mode
- 5 -
4010DUO
40A@Asyn. Mode
1.2A@Asyn. Mode