Advertisement
II. Quick Setup
Your access point can be up and running in just a few minutes. It can function
as a standalone access point (AP mode) or as part of an AP array (Managed AP
mode or AP Controller mode). This quick installation guide will help to set up
your access point and configure its basic settings.
II-1.
Initial Setup
1.
Connect the access point to a computer via Ethernet cable.
2.
Connect the power adapter to the access point's 12V DC port and plug the
power adapter into a power supply using the included cable.
3.
Please wait a moment for the access point to start up. The access point is
ready when the LED is blue.
4.
Set your computer's IP address to 192.168.2.x where x is a number in the
range 3 – 100. If you are unsure how to do this, please refer to the user
manual for more information.
Please ensure there are no other active network connections on
your computer (disconnect Wi-Fi connections and Ethernet
cables).
5.
Enter the access point's default IP address 192.168.2.2 into the URL bar of
a web browser.
5
Advertisement
