Chapter Ii: System And Network Setup; Installing The Access Point To Your Network - Edimax EW-7428HCn User Manual

Chapter II: System and Network Setup

2-1 Installing the access point to your Network

Please follow the following instruction to build the network connection
between your new wireless access point and your computers, network
devices:
1. Place the unit in an appropriate place after conducting a site survey.
2. Connect the access point to ADSL modem, router, or switch/hub in
your network through the LAN port of the access point by Ethernet
cable.
3. Connect the A/C power adapter to the wall socket, and then connect it
to the „Power‟ socket of the access point.
4. Please check all LEDs on the front panel. „PWR‟ LED should be
steadily on, LAN LEDs should be on if the access point is correctly
connected to the ADSL modem, router or switch/hub. If PWR LED is
not on, or any LED you expected is not on, please recheck the cabling,
or jump to '4-2 Troubleshooting' for possible reasons and solution.
7