II
Quick Setup & Mode Selection
The unit can function as a standalone access point (AP Mode), as a repeater
(Repeater Mode), as part of an AP array (Managed AP Mode), or as a client
bridge (Client Bridge Mode).
Follow the default mode steps below and select the desired operation mode.
II-1
Default Mode: Access Point Mode
1.
Set your computer's IP address to 192.168.2.x where x is a number in
the range 3 – 100. If you are unsure how to do this, please refer to
Configuring your IP address for more information.
Please ensure there are no other active network connections on your
computer by disabling Wi-Fi and other Ethernet connections.
2.
Wire an Ethernet cable to the LAN 1 (PoE-In) port of the access point
and the PoE switch to power up the access point.
LAN 1 (PoE-In) Port
3.
Please wait a moment for the device to start up. The device is ready
when the Power LED is turned on.
4.
Connect a computer to the switch using an Ethernet cable.
6
V -1