Omron BU1002SW Instruction Manual page 69

2-2 Settings
The UPS operation mode can be set if the power switch is turned ON while the beeper stop switch is
pressed.
Note: While in setting mode, output from the power supply output is OFF even if the power switch is
ON.
(1) When the beeper stop switch is briefl y pressed (for less than 1 second), the next item is displayed.
(2) The unit enters the "individual item setting mode" when the beeper stop switch is pressed and held
(for more than 1 second).
(3) When the power switch is turned OFF, the setting mode quits and the unit enters power switch OFF
status (status No.2).
バッテリ ブザー停止/テスト
電源出力
増設
-
バイパス バッテリ
運転 交換
Cold start ON/OFF setting
Output voltage setting
Power supply output stop delay time setting
Signal input/output test
1002 3002
BU SW / BU SW
4
47