Battery Indicator; Charging Time And Available Recording Time - Panasonic Lumix DMC-FZ2A Operating Instructions Manual

ª Battery indicator
The remaining battery power is displayed on the LCD monitor/Viewfinder. (This is
not displayed when using AC adaptor)
: The battery power is sufficient
: The remaining power is a little low
: The remaining power is low
: Recharge or replace the battery
ª Charging time and available recording time
(Recording condition)
• Temperature: 25oC/Humidity: 60%
• Shooting once every 30 seconds, flash every other shot.
• Using the supplied SD Memory Card (Recording size: 1600k1200/Quality: Fine/
When deleting all pictures after full use)
Supplied battery
The times shown in the table are approximate times. The times may vary depending
on the condition.
ª Charging environment and charging error
• Charge the battery in a place with a temperature of 10 – 35oC. (The battery should
also be the same temperature)
• When charging starts, the [CHARGE] indicator lights. If, after charging starts, the
[CHARGE] indicator blinks at about 1 second cycles, this indicates a charging
error.
In this case, remove the AC adaptor from the electrical outlet, remove the battery
and check if both room and battery temperature is too low or high and then charge
it again. If the problem persists, consult the dealer or your nearest servicentre.
Preparation
Continuous recording/playback time
Charging time
(recordable number)
Recording with LCD monitor
Approx. 100 min.
(equal to 200 still pictures)
Recording with Viewfinder
Approx. 90 min.
Approx. 120 min.
(equal to 240 still pictures)
Playback with LCD monitor
Approx. 120 min.
13